Available 7 files for D-Link DAP-1160

Company

D-Link

Categories

Networks Cards

Model

D-Link DAP-1160

Description

Wireless G Access Point Firmware

Operating System

Firmware

Version

1.11

Size Driver

1.3MB

File Name

dap-1160_fw_v1-11b01.zip

Observations

DAP-1160 Firmware Release Note

Firmware: v1.11.b01
Hardware: A1
Date: Aug 30, 2007

Problems Resolved:
1. Fix DCC bug : it can only run with eth2 and can not run with eth1.

Firmware: v1.10.b15
Hardware: A1
Date: July 30, 2007

Problems Resolved:
1. Bug fix: the DHCP server supports the wrong DNS IP to DHCP client.
2. Limited the site survey STAs to 30 to prevent the platform crash.
3. Fixed the configure table problem that will make bridge mode fail.
4. Make the boot code to support tftp update directly.
5. Bug fix: When DHCP enabled on AP client or repeater mode, LAN PCs can’t get current gateway address.
6. Bug fix: If other AP’s SSID contain '“' , UI will work fail on survey page.
7. Bug fix: When the WISP is enabled, the LAN setting will happen some problems: (a). can not set DHCP disable. (b). The gateway will not follow the IP.
8. Change login time out to three minutes.
9. Remove "Auto WPA-PSK/WPA2-PSK" from UI of client and repeater.
10. Modify the "Status" LED behavior into blinked.
11. Bug fix: When the DHCP is enabled, it will not set the route table for br0 device. Then the AP will not be ping through VLAN.
12. Bug fixed : In SETUP/Wireless Setup page , in AP or Bridge with AP mode if user sets wep64 and key in hex characters and run apply first, and then user sets wep128 and key in ASCII characters,. After applying, the UI will display error.
13. Add two operation modes: WISP Client Router and WISP Repeater mode.
14. Support WMM in AP mode.
15. Add Watch Dog function.
16. Modify the UI for D-link request.
17. Bug fix: vista wireless client with Atheros wireless card can’t connect to the DAP-1160.

Company

D-Link

Categories

Networks Cards

Model

D-Link DAP-1160

Description

Wireless G Access Point Firmware

Operating System

Firmware

Version

1.30

Size Driver

1.5MB

File Name

dap-1160_fw_1.30b10.zip

Observations

DAP-1160 Firmware Release Notes

Firmware: v1.30b10
Hardware: A1
Date: 2009/7/21

Problems Resolved:
1. When operate as repeater or AP client mode, sometimes client will be disconnecting.
2. AP Client and Repeater mode will not forward share port packets of DIR-655.
3. When setting to DHCP server, the gateway info will show all zero.
4. Watch dog function sometimes no response.
5. Fail to connect to AP when operate as AP client mode using WPA/WPA2-PSK encryption.
6. Fail to connect g only mode using Wii.
7. When setting to DHCP server, the gateway info will show all zero.

Enhancements:
1. Update DCC protocol to v2.0.
2. Support MAC Clone on AP Client mode.
3. Support UPnP IGD.
4. Support Microsoft LLTD (Link Layer Topology Discovery) protocol
5. Support 802.1d with spanning tree protocol
6. Support WMM (Wi-Fi Multimedia) for AP Client mode.

Company

D-Link

Categories

Networks Cards

Model

D-Link DAP-1160

Description

Wireless G Access Point Firmware

Operating System

Firmware

Version

v1.31

Size Driver

1.5MB

File Name

dap1160a1_fw131b01.zip

Observations

DAP-1160 Firmware Release Notes
Firmware: v1.31b01
Hardware: A1
Date: 2009/8/28

Problems Resolved:
1. The IPSec function in port forwarding of the Advanced page is failed.
2. When user enables Netmeeting in port forwarding, the FTP and messages are failed.
3. The DHCP server will be disabled after setting from wizard.
4. Endurance failure with 11n client.
5. When running TP between WLAN and LAN, there will be many low peaks.

-----------------------------------------------------------------------------------------------------------------------------------

Firmware: v1.30b10
Hardware: A1
Date: 2009/7/30

Problems Resolved:
1. When operate as repeater or AP client mode, sometimes client will be disconnecting.
2. AP Client and Repeater mode will not forward share port packets of DIR-655.
3. When setting to DHCP server, the gateway info will show all zero.
4. Watch dog function sometimes no response.
5. Fail to connect to AP when operate as AP client mode using WPA/WPA2-PSK encryption.
6. Fail to connect g only mode using Wii.
7. When setting to DHCP server, the gateway info will show all zero.

Enhancements:
1. Update DCC protocol to v2.0.
2. Support MAC Clone on AP Client mode.
3. Support UPnP IGD.
4. Support Microsoft LLTD (Link Layer Topology Discovery) protocol
5. Support 802.1d with spanning tree protocol
6. Support WMM (Wi-Fi Multimedia) for AP Client mode.

Company

D-Link

Categories

Networks Cards

Model

D-Link DAP-1160

Description

Wireless G Access Point Quick Installation Guide

Information

Quick Installation Guide

Operating System

Manual

Size Driver

2.1MB

File Name

dap-1160_qig.pdf

Observations

Troubleshooting
1. How do I configure my DAP-1160AP without the CD, or check my Wireless Network Name
(SSID) and Wireless Encryption Key?
•Connect your PC to the Access Point (AP) using an Ethernet cable.
•Open a web browser and enter the address http://192.168.0.50
•The default username is ‘admin’. The default password is ‘’ (leave the field blank)
•If you have changed the password and can not remember it, you will need to reset the AP to
set the password back to ‘’ (leave the field blank).
2. How do I reset my AP to factory default settings?
•Ensure the Access Point is powered on.
•Press and hold the reset button on the rear of the device for 20 seconds.
Note: Resetting the AP to factory default will erase the current configuration settings. To reconfigure
your settings, log into the AP as outlined in question 1, then run the Setup Wizard.
3. How do I add a new wireless client or PC if I have forgotten my Wireless Network Name
(SSID) or Wireless Encryption Key?
•For every PC that needs to connect to the AP wirelessly, you will need to ensure you use the
correct Wireless Network Name (SSID) and encryption key.
•Use the web based user interface (as described in question 1 above) to choose your wireless
settings.
•Make sure you take a note of the settings so that you can enter them into each wirelessly
connected PC. D-Link has provided a handy sticker for you to note them down and attach to
your AP, or other location you find most convenient.
4. What can I do if my AP is not working correctly?
•The manual contains a full troubleshooting section and can be downloaded from the D-Link
website (see below), however there are a few quick steps you can take to try and resolve any
issues:
•Check the LED’s on the front of the AP. The Power, Wireless, and Status LED should be on.
One or more of the LAN LED should flash.
•Check that all the cables are firmly connected at both ends.
•Power the AP off for 20 seconds, and then power it back on.
Note: If you are unable to connect, see the Troubleshooting chapter of the product manual in
the D-Link DAP-1160 Wireless G Access Point.

Company

D-Link

Categories

Networks Cards

Model

D-Link DAP-1160

Description

Wireless G Access Point Datasheet

Information

Manual

Operating System

Manual

Size Driver

3.3MB

File Name

dap-1160.pdf

Observations

CONNECT HOME AND SOHO TO A WIRELESS NETWORK
Create a wireless network for your home and office using the D-Link DAP-1160 is an 802.11g standard Wireless Access Point. Connect this Access Point to a
broadband modem and wirelessly share your Internet connection. Enjoy surfing the web, checking e-mail, and chatting with family and friends online.
PROTECT WIRELESS NETWORK AND DATA
The DAP-1160 provides 64/128-bit WEP encryption and WPA/WPA2 security to protect your network and wireless data. In addition, it also provides MAC
address filtering and the Disable SSID Broadcast function to limit outsiders’ access to your home and office network.
FLEXIBLY CONFIGURE YOUR AP FOR DIFFERENT APPLICATIONS
The DAP-1160 can be configured to operate as (1) an Access Point to act as a central hub for wireless users, (2) an AP Client to connect to another Access
Point, (3) a Bridge to joint two wireless workgroups together, (4) a Bridge with AP to act as wireless hub and a bridge at the same time, (5) a Repeater to
extend the wireless coverage to cover all “dead” spots, (6) a WISP Client Router to let wireless Internet service subscribers share Internet connection with
home/office Ethernet-enabled computers without the need for an extra router, or (7) a WISP Repeater to let WISP subscribers share Internet connection with
wireless computers without any extra router.
EASY TO INSTALL AND USE
With D-Link Click n’Connect, you can set up your wireless network in minutes. It configures your DAP-1160’s operation mode, makes it easy to add new
wireless devices onto the network, and helps you create a simple wireless network for your home and office.

Company

D-Link

Categories

Networks Cards

Model

D-Link DAP-1160

Description

Wireless G Access Point Manual v1.30

Information

Manual

Operating System

Manual

Size Driver

2.2MB

File Name

dap-1160_manual_v1.30.pdf

Observations

Product Overview........................................................4
Package Contents ...................................................4
System Requirements .............................................4
Introduction..............................................................5
Features ..................................................................6
Hardware Overview .................................................7
Connections.......................................................7
LEDs..................................................................8
Configuration ...............................................................9
Web-based Configuration Utility ..............................9
Setup Wizard ...................................................10
Wireless Setup.................................................11
Access Point ................................................12
AP Client ......................................................13
Bridge...........................................................14
Bridge with AP..............................................15
Repeater ......................................................16
WISP Client Router ......................................17
WISP Repeater ............................................17
WAN Settings ..................................................18
Dynamic IP (DHCP) .....................................18
Static IP........................................................19
PPPoE..........................................................20
PPTP............................................................21
LAN Setup .......................................................22
LAN Settings ................................................23
Advanced...............................................................25
Port Forwarding ...............................................25
Port Filter .........................................................26
Access Control.................................................27
DMZ.................................................................28
Parental Control...............................................29
Advanced Wireless ..........................................30
Advanced Network...........................................31
Traffic Management Settings...........................32
Maintenance ..........................................................33
Device Administration ......................................33
Save and Restore ............................................33
Firmware Update .............................................34
Watchdog (Ping of Life) ...................................35
Status ....................................................................36
Device Info.......................................................36
Log...................................................................37
Stats.................................................................38
Wireless ...........................................................38
Help .......................................................................39
Wireless Security.......................................................40
What is WEP? .......................................................40
Configure WEP......................................................41
What is WPA? .......................................................42
Configure WPA-PSK (Personal)............................43

Company

D-Link

Categories

Networks Cards

Model

D-Link DAP-1160

Description

Wireless G Access Point GPL Source Code

Operating System

Software

Version

1.30

Size Driver

54.7MB

File Name

dap-1160_gpl.tar.gz

Observations

DAP-1160 GPL Source Code RTL8186 LINUX Application Source Package - v13